Open IE browser and input the ICOM configuration address (IP address http//***.***.***. Run ITool Radar and read ICOM Next device info (IP address) You need: good router working for your Icom Next interface Look here: How to setup WiFi for BMW ICOM Next A+B+C Disconnect LAN cable and restart ICOM, then ICOM will auto connect with WiFi. Added BMW ISTA/P release notes 2.53.5 and I-level overview - Expert mode is already enabled. Select WLAN Settings Enter WiFi settings Save Changes. Additional info: - Install Ediabas 7.3.0 from BMW Standard Tools 2.12 - Included programs Eas圜onnect x32 圆4, iTool Radar x32 圆4, EasyKFP, Ediabas Konfigurator - Included ICOM firmware 3.10.45 3.12.02. Open IE browser and enter ICOM configuration address (based on current real ICOM IP ) 3. How to Set up BMW ICOM Next WiFi Connection? Run ITool Radar to detect ICOM information 2. I just installed ITool Radar on my 64bit Dell. (, 04:06 AM) bmsmbs Wrote: I am wanting to connect my genuine ICOM to BMW Standard Tools software and I understand that I need to configure the connectivity setup using ITool Radar.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |